View Revisions: Issue #5348

Summary 0005348: Clipper cursor persists when switching out of clipper mode
Revision 30.09.2020 18:43 by Dragofer
Description When hovering the cursor over clipper points (placed by LMB when the clipper tool is active), the cursor turns into a cross. If I switch out of the clipper tool (i.e. press W) while my cursor is in that position, it'll remain a cross indefinitely in orthoview.

This can be reversed by passing the cursor over a clipper point again.
Revision 30.09.2020 18:42 by Dragofer
Description When hovering the cursor over clipper points (placed by LMB when the clipper tool is active), the cursor turns into a cross. If I switch out of the clipper tool (i.e. press W) while my cursor is in that position, it'll remain a cross indefinitely.

This can be reversed by passing the cursor over a clipper point again.
Revision 30.09.2020 18:41 by Dragofer
Description When hovering the cursor over clipper points (placed by LMB when the clipper tool is active), the cursors to turn into a cross. If I switch out of the clipper tool (i.e. press W) while my cursor is in that position, it'll remain a cross indefinitely.

This can be reversed by passing the cursor over a clipper point again.