View Revisions: Issue #5348

Summary 0005348: Clipper cursor persists when switching out of clipper mode
Revision 30.09.2020 18:43 by Dragofer
Steps To Reproduce 1) Activate the clipper tool (X), left click to place a clipper point.
2) Hover the cursor over this clipper point. It turns into a cross.
3) Without moving the mouse, go into translate mode by pressing W. The cursor is now always a cross in orthoview.

To undo, return to the clipper tool, place a new clipper point and pass the cursor over the point.
Revision 30.09.2020 18:41 by Dragofer
Steps To Reproduce 1) Activate the clipper tool (X), left click to place a clipper point.
2) Hover the cursor over this clipper point. It turns into a cross.
3) Without moving the mouse, go into translate mode by pressing W. The cursor is now always a cross.

To undo, return to the clipper tool, place a new clipper point and pass the cursor over the point.