View Revisions: Issue #5444

All RevisionsBack to Issue
Summary 0005444: Brushes with no visible surface towards orthoview "camera" are unselectable in orthoview
Revision 26.12.2020 14:03 by Dragofer
Steps To Reproduce 1) Create a brush, texture it with caulk. Duplicate it and move the copy to the side horizontally.
2) Apply the rough_wood_darkbrown material to the upfacing surface of one brush and to the downfacing surface of the other brush.
3) Make sure you're in top-down orthoview, then enable the caulk filter.
4) Drag-select over where both brushes should be. Only the brush with the topfacing rough_wood_darkbrown surface becomes selected.
Revision 16.12.2020 13:16 by Dragofer
Steps To Reproduce 1) Create a brush, texture it with caulk. Duplicate it and move the copy to the side horizontally.
2) Apply the rough_wood_darkbrown material to the upfacing surface of one brush and to the downfacing surface of the other brush.
3) Make sure you're in top-down orthoview, then enable the caulk filter. The brush that has rough_wood_darkbrown on its downfacing surface disappears in orthoview.
4) Drag-select over where both brushes should be. Only the brush with the topfacing rough_wood_darkbrown surface becomes selected.