| Description | Hopefully just a tiny thing here. If you use the spin controls on the Surface Inspector, they don't set focus on the value text boxes. Focus is not put there unless you specifically put it there. But on the Patch Inspector, focus is put on the value boxes as soon as you use the spin controls. The problem? Once you're done doing manipulations, you type your hotkey to close the dialog, and you end up with "S4.000" or whatever (e.g., where hotkey = "shift-s").
You can get around it by hitting ESC first, to clear the patch selection, but then we're back at hitting ESC again, and in fact, now it's two steps: ESC and hotkey. |
|---|
